i managed to get my atmega8 programed i verified a few time and read to make sure and compare with the hex all is fine
however
i connected it to the box
done all the hadrive files except the tv2client as dont know where toi look for patched one
thing is my box says starting then it shuts down after 20 secs
could this mean the chip not working/wiring is wrong or files on hdd are wrong
to clarify i linked 22 and 8 gnd on the chip then soldered a wire to gnd on the bt box
i done the same with both vcc
can you help with these files for the hard drive and y my boxs boots then sort of switches off
I think you have posted in the wrong section, this is the German section for the X300T / X301T..
You need to post in the English BT Vision Section.
Mick