Messages

1

Hardware / cant access my box please help

10. Nov 2009, 18:46

i have followed all the guides i have my chip programed,verified,soldered,and all points check they perfect
but i need help i cant access my box
ive tried using ftp and http into the box
but nothing works i get connection refused


but i can ping the box and i get a reply
does this mean my chip is not working or can you not ping with out modchip working

all my box does is starting then goes blank(no video signal)flashing green light on front of the box

iso-mick says this is normal behaviour as i dont get any errors so we think my chip is working

any info
also my firewall is off

2

Software / Box restarts or is it supposed to to this

08. Nov 2009, 21:39

i managed to get my atmega8 programed i verified a few time and read to make sure and compare with the hex all is fine
however
i connected it to the box
done all the hadrive files except the tv2client as dont know where toi look for patched one

thing is my box says starting then it shuts down after 20 secs
could this mean the chip not working/wiring is wrong or files on hdd are wrong

to clarify i linked 22 and 8 gnd on the chip then soldered a wire to gnd on the bt box
i done the same with both vcc


can you help with these files for the hard drive and y my boxs boots then sort of switches off