UART0
From t-hack.com - Hack X300T / X301T
(UART0 page added) |
m (→General information on the Serial Ports) |
||
| Line 8: | Line 8: | ||
UART0 is used to output some debug information during startup, unfortunately most of the debug output in the Bootloader was disabled, so there is not much to see during startup. | UART0 is used to output some debug information during startup, unfortunately most of the debug output in the Bootloader was disabled, so there is not much to see during startup. | ||
| + | |||
| + | the serial port settings are 115000 baud and 8N1 | ||
<pre> | <pre> | ||
| Line 25: | Line 27: | ||
The only interesting information on this output is the bootloader version ... 1039 in this case. | The only interesting information on this output is the bootloader version ... 1039 in this case. | ||
| − | |||
== How to built a debug interface == | == How to built a debug interface == | ||
